All Articles
  1. Remove the vertical trim strip at the rear of the door opening, two Philips head screws.
  2. Remove three Philips head screws on the outside of the carpeted sill panel.
  3. Pull the sill panel up and out of the rubber seal strip at the front of the door opening.
  4. The speaker amplifier assembly is attached to the chassis with four 7 mm hex head sheet metal screws.
  5. Disconnect the 4-wire connector.
  6. The amplifier is under an access panel - remove it.
  7. Disconnect the multi-pin connector and remove the amp circuit board.

Author: Glen Breitung
Posted in: Electronics
Actions: E-mail | Permalink |

The information contained in this website is for general information purposes only. Whilst we endeavor to keep the information up-to-date and correct, we make no representations or warranties of any kind, express or implied, about the completeness, accuracy, reliability, suitability or availability with respect to the website or the information, products, services, or related graphics contained on the website for any purpose. Any reliance you place on such information is therefore strictly at your own risk.

In no event will we be liable for any loss or damage including without limitation, indirect or consequential loss or damage, or any loss or damage whatsoever arising from loss of data or profits arising out of or in connection with the use of this website.

Through this website there are links to other websites which are not under the control of the ZR-1 Net Registry. We have no control over the nature, content and availability of those sites. The inclusion of any links does not necessarily imply a recommendation or endorse the views expressed within them.

Read the full Disclaimer...

©2019 ZR-1 NET Registry   |  Privacy Statement