All Articles
Tools Required:

A good trolley jack

Axle stands

 
Procedure:
I use two floor jacks placed in the positions shown above. The picture shows the forward position on the driver side. I place the jack on the inside of the frame on a flat section just as the frame turns in toward the engine compartment. Note the rear jack placement is also in place and both are brought up at the same time. The jack stand here is shown straddling the lip. You can get a bearing if you note the CAT in the picture.
This is the rear shot (taken out of sequence. The other side would not normally be up yet) Note the floor jack in on the lip where the "locator arrows" are. The jack stand is set in a very convenient location. (above) but see even better detail below.
 
The stand mounts very nicely in the partial rectangle area.
 
This is a view of the car up on one side. Now for the other side.  
Both are jacked at the same time.  
This is the passenger side front jack stand straddling the lip.  
That is all there is to it, very stable. No jack-a-vett or anything. It takes me 15 minutes to get this result.  
Related Articles:
 Michael Hom's Article
Author: Scott Fabre
 
Actions: E-mail | Permalink |
  Disclaimer

The information contained in this website is for general information purposes only. Whilst we endeavor to keep the information up-to-date and correct, we make no representations or warranties of any kind, express or implied, about the completeness, accuracy, reliability, suitability or availability with respect to the website or the information, products, services, or related graphics contained on the website for any purpose. Any reliance you place on such information is therefore strictly at your own risk.

In no event will we be liable for any loss or damage including without limitation, indirect or consequential loss or damage, or any loss or damage whatsoever arising from loss of data or profits arising out of or in connection with the use of this website.

Through this website there are links to other websites which are not under the control of the ZR-1 Net Registry. We have no control over the nature, content and availability of those sites. The inclusion of any links does not necessarily imply a recommendation or endorse the views expressed within them.

Read the full Disclaimer...

©2019 ZR-1 NET Registry   |  Privacy Statement