Seslendirme


70 Dilde Yabancı Dil Seslendirme, Televizyon Reklam Filmleri, Kurumsal Tanıtım Filmleri, Radyo Reklam Spotları, Radyo Jingle ve Dj Jingle Servisi, Kapalı Devre Radyo, Mağaza Radyo, Mağaza Anons ve Kesintisiz Muzik Yayıncılık Sistemleri, IVR Seslendirme, Santral Anons ve Santral Seslendirme, Siyasi Parti Reklam ve Secim Kampanyaları.

Seslendirme projeleriniz icin şu alt başlıklarda sizlere hizmet sunmaktayız, Reklam Seslendirme, Santral Seslendirme, Tanıtım Filmi Seslendirme, Mağaza Anons Seslendirme, Haber Seslendirme, Perfore Seslendirme, Jingle Seslendirme, Secim Seslendirme, Yabancı Dil Seslendirme, Animasyon Seslendirme, E-Kitap Seslendirme, DJ Jingle Seslendirme, Tesis Anonsu Seslendirme, Sesli Mesaj Seslendirme, Medikal Seslendirme, Belgesel Seslendirme, Sponsorluk Seslendirme, IVR Seslendirme, Eğitim Filmi Seslendirme, Santral Anons Seslendirme. Temsil etitğimiz ve anlaşmalı olan seslendirme ekibimiz sanatcıları projelerinize hayat vermek icin sizleri bekliyor. En profesyonel yabancı dil seslendirme cozumlerine en uygun fiyatla sahip olmak istiyorsanız bize telefon, email veya canlı destek hattımız aracılığı ile ulaşmanız yeterli olacaktır.

Reklam Seslendirme Çalışmaları Kısa Sürede Teslim Edilir!

Reklam seslendirme çalışmasını gerçekleştirmek isteyen markalar, firmalar veya kişiler akıllarında olan fikirleri ya da yaratıcı bir düşünme sonunda elde ettiği sloganları hemen gerçeğe dönüştürerek bir reklam içinde duymak isterler. Bunun bilincinde olan firmamız en iyi şekilde değerlendirmelerini yapmak için radyo reklam seslendirme ve televizyon reklamlarını seslendirmede çok kısa sürede seslendirme çalışmasını tamamlayarak kayıtların teslim edilmesini sağlamaktadır. Son derece hızlı çıktı alınabilen teknik altyapımız sayesinde reklam seslendirmeye yönelik taleplerin bize gelmesinin ardından bir gün içerisinde seslendirmeyi teslim edebiliyoruz.

Çalışma şekli olarak firmamızın benimsediği yol öncelikle birebir görüşmelerle seslendirme hizmetinden neler beklendiğine yönelik olmaktadır. İki tarafın anlaşmalı şekilde seslendirme projesine ortak olmasından sonra reklamda seslendirilecek olan metinleri talep ediyor ve bir günlük süre içerisinde bu çalışmayı tamamlayarak sizlere dönüt verebiliyoruz. Sürekli olarak kullanılan reklam sloganlarınız veya seslendirme metinlerinizin mevcut olduğu durumlarda elektronik posta yerine sitemizi de kullanarak en hızlı şekilde bizlerle iletişime geçebilirsiniz.

Etkileyici Seslerle Televizyon Reklamlarında İlgi Çekin!

Televizyona yönelik olarak hazırlanan reklam filmleri ve tanıtımlarda daha çok görsel bir zemin üzerine bu reklamların hazırlanması söz konusu olduğu için pek çok kişi ses altyapısının nasıl hazırlanması gerektiğini arka planda bırakarak görsel odaklı bir etkileme yöntemini bulmaya gayret etmektedir. Oysa tv de en az radyo kadar seslendirmenin önemli olduğu bir alandır. Özellikle televizyon izleyicisinin çok farklı yönlerden uyarılarak reklamlardan etkilenmesini sağlamak için mutlaka televizyon reklam seslendirme çalışmalarında da profesyonel destek almak gerekiyor.

Seslendirme

reklam seslendirme

  ZR-1 Maintenance Tips

General Maintenance

by Jim VanDorn

 

The most common call we receive by far is from a confused ZR1 owner. After years of reading everything from which thermostat to use, to what type of spark plug is best, the average owner is totally and completely confused...and for good reason. There are many varied opinions of what is best for our cars but that may depend greatly on how you use your ZR1.

 

After seven years plus, many ZR1's are finally accruing some mileage. We have had the opportunity to closely inspect many engines with a variety of types of use from normal street driving to severe "weekend" use (track time). Compiling this information we can now offer the ZR1 owner some observations. One rule we've adopted after hearing so many owners say the same thing is the "DIMWIT" or "Darn, if I didn't Mess With IT" rule. In other words, if you didn't have a problem, then what are your intentions in the first place? To date, the only company known to have a fleet of engineering ZR1's to test with was GM and it's affiliates.

 

Therefore, we must ask ourselves if their suggested procedures and parts recommendations should have a considerable amount of merit. Obviously they do, but on the other hand, there are no doubt areas for improvement. Although we will begin our segment discussing the routine and normal maintenance of the ZR1, there are many areas where an upgrade will be suggested.

 

Please understand that these are personal opinions and experiences and are not intended to conflict with service procedures outlined in the appropriate service manual.


  Articles
Symptom: Engine starter will not engage -an intermittent situation: (*NOTE: This study does not apply to conditions of non-starting when the starter engages and the engine turns over without firing.) The battery usually seems fine, and the engine may have just been running, (possibly at a high heat level). The engine is turned off for a brief period. When the key is turned to restart the engine, nothing happens. Usually, the engine will restart after some short period of inactivity. Some have reported that after giving up on starting attempts and towing a car to the shop or home, the engine would then start with a turn of the key from then on as if nothing were ever wrong. Another diagnostic clue will be if you have interior lights, power windows, dash cluster and gauge readings or not.

Possible causes and corrective measures

First, make extremely certain that the clutch pedal is ALL the way down to the floor. Push it very, very hard. Make sure there is no obstruction of floor mat or debris. This seems to be the most common of the problems encountered in a no start situation. Many ZR1's that just experienced a no start have been subsequently started by those who knew the procedure by mashing the clutch pedal to the floor and starting the car to the amazement and disbelief of the frustrated owner who had tried so hard and given up.

It is plainly described in the owner's manual, that the VATS or PASS-Key security system will shutdown the starter and fuel system for about three minutes after a failed start situation occurs. There are reports that this time can be more like 5 of 6 minutes in some cars. This further compounds the frustration as the driver tries again and again to turn the key hoping for luck on his side - in that special way holding one's mouth just right as the old story goes. But each time the key is turned or another key is used before the shutdown period ends, the shutdown time starts all over again, and again. Disconnecting the battery will NOT change the time period of shut down since it is stored memory in the CCM's EEPROM. If the CCM sees a wrong resistance, (or no resistance) when the key is turned to START, a code 54 will be set. If there is any CCM code set, your cluster will flash. If the VATS system fails, it will not turn on the fuel pump when you first turn the key to ON you should be able to hear the silence. Attempts to jump start are also futile within this VATS security time constraint. It is best to just walk away or wait about 10 minutes before trying again.

Stories have been circulated about the infamous purple wire from the clutch switch to the starter motor that rubs on the engine or chassis and shorts out. Replacement of this wire has had varying degrees of reported success with some owners claiming full recovery, and others claiming it did no good. Bypassing the clutch switch with a wire splice has been reported to end this problem for some - (although it is dangerous since the car can then be started in gear). The switch is WAY up there under the dashboard as Gordy Bates describes it, so you will need to be supple. The black connector with a purple wire is the target to find coming from the clutch switch (part# 10045822) - Unplug it and jump across the two male spade connections with a #10 wire with a female connector crimped on each end . The Black Connector itself may be part of the problem with a high resistance (poor) connection where both halves snap together. By bypassing it with new crimp connectors you are certain to get a good connection.

Also: There is an easy way to check the clutch safety switch, assuming the starter isn't starting. Set the parking brake, put the shifter in neutral, and watch the voltmeter while you turn the key to the start position. The voltage will drop slightly. While holding the key in start, release the clutch pedal. If the voltage goes up and down in response to clutch pedal movement, the clutch switch works.

Some reports of faulty ignition key wires within the steering column have been reported. The wires have a tendency to rub with each startup as the ignition key is turned from off to start, and occasionally short out. (DTC53or52) See your dealer for replacement.

Reports of wet or contaminated key resistors has been cited, noting that the SECURITY light will come on in such instances. But if cleaning and drying the key does not work, and another key is available, the owner's manual says try the new key. Always check the fuses too.

Many claims of the poorly drained starter motor position and/or wiring being affected by water intrusion / corrosion under the plenum make this one of the most frequent diagnoses. But there are others who report that this is not an absolute cause or fix.

A low battery due to age, climatic conditions, or electrical system inadequacies may play a part in the dilemma because those with brand new batteries never seem to report a no-start situation. Always have your battery checked by a professional before tearing down engine or clutch pedal parts. It is characteristic of some batteries to have a tendency to only partially charge after full discharge situations. It is necessary in some cases to slowly charge the battery for extended periods in order to reach the optimal charge level. Remember, your LT5 is a high compression engine that requires a good amount of battery power.

In emergency situations (or if you just will not wait any longer), the car can be pushed by hand with a helper or two to about 5 miles an hour with someone in the driver's seat - with the ignition key in the RUN position the clutch in and the gearshift in the second gear position then, while rolling along - letting out the clutch quickly will start the car. Of course, we want the starter to always work, so this is a temporary resort; but, it seems to work for all reporting this condition. Of course, if it is a VATS problem or wrong key (DTC61), the car will not start no matter how far you push.

Another possible curative measure - if the VATS system is the problem, try unlocking the driver's door with the door key a couple of times. The door key switch deactivates the UTD alarm and this switch is known fail after time.

Post Comment
Only registered users may post comments.
  Disclaimer

The information contained in this website is for general information purposes only. Whilst we endeavor to keep the information up-to-date and correct, we make no representations or warranties of any kind, express or implied, about the completeness, accuracy, reliability, suitability or availability with respect to the website or the information, products, services, or related graphics contained on the website for any purpose. Any reliance you place on such information is therefore strictly at your own risk.

In no event will we be liable for any loss or damage including without limitation, indirect or consequential loss or damage, or any loss or damage whatsoever arising from loss of data or profits arising out of or in connection with the use of this website.

Through this website there are links to other websites which are not under the control of the ZR-1 Net Registry. We have no control over the nature, content and availability of those sites. The inclusion of any links does not necessarily imply a recommendation or endorse the views expressed within them.

Read the full Disclaimer...

©2020 ZR-1 NET Registry   |  Privacy Statement