One area where large mistakes are made regarding the LT5 is in the clutch/flywheel department. The LT5's clutch has an approximate service life of 40,000-50,000 miles but this varies greatly depending on the type of usage. No doubt some owners can get more and there are those who can claim half (or less) of that.

When servicing a clutch assembly, most technicians will see the flywheel's dark spotted appearance and immediately suggest re-surfacing the flywheel. DO NOT allow this to be done. As warned against in the service manual, the dual mass flywheel must not be surfaced. This appearance really does not reduce the clutch's effectiveness or hamper it's operation. Unless you have felt some previous vibration, noise or other problem, leave the flywheel undisturbed. Your flywheel, if original, was balanced with your engine, therefore, a replacement will not be as accurately balanced (see "Other Flywheel Concerns" below). If there are visible groove, etc., on the flywheel, then there is no choice but to replace the unit with a new one available from your dealer for approximately $800.

Also important in the clutch area is the replacement of the throwout bearing and pilot bushing. Do not panic if the pilot bushing is loose within the crankshaft. This is common and a source for many loud clutch related noises. If ignored, the loose bushing may enlarge the crankshaft hole so excessively, the newer bushing will not seat. This will be cause for some creative machine work.

There has been much confusion over which bushing is to be used. GM has changed their part numbers several times and are currently referring to the bearing (part #14061685) to be used. We strongly suggest NOT using this bearing as it is a needle type bearing designed for 6.2L diesel trucks which have a limit of only 4,000-4,500 rpms. You can imagine how fast those little needles will turn at over 7,000 rpms. We have seen some failures which were quite interesting. The ideal bushing replacement is a bronze type with three grooves (or flutes) spiraled inside and is available under the GM part number 10125896.

Special Note: Some of you may have had the occasion to replace a pilot bushing on engines other than the LT5 by filling the hole with grease and then using a punch to force the bearing out by the hydraulic method. This will cause major problems if done on the LT5 as it is a hollow crankshaft with a plug seated at the end. Carefully use the appropriate tools for removal and installation of the LT5 pilot bushing.

Actions: E-mail | Permalink |

The information contained in this website is for general information purposes only. Whilst we endeavor to keep the information up-to-date and correct, we make no representations or warranties of any kind, express or implied, about the completeness, accuracy, reliability, suitability or availability with respect to the website or the information, products, services, or related graphics contained on the website for any purpose. Any reliance you place on such information is therefore strictly at your own risk.

In no event will we be liable for any loss or damage including without limitation, indirect or consequential loss or damage, or any loss or damage whatsoever arising from loss of data or profits arising out of or in connection with the use of this website.

Through this website there are links to other websites which are not under the control of the ZR-1 Net Registry. We have no control over the nature, content and availability of those sites. The inclusion of any links does not necessarily imply a recommendation or endorse the views expressed within them.

Read the full Disclaimer...

©2019 ZR-1 NET Registry   |  Privacy Statement